USG Fiberock is a fiber - reinforced gypsum angel board with a flat , level surface and used for the installation of tiling . It is exceedingly strong and bouncy , dear for moist conditions where distinctive drywall would be a poor choice .

USG Fiberock is a fiber - reenforce gypsum backer board with a flat , level control surface and used for the installation of tiling . It is extremely strong and springy , good for moist conditions where typical wallboard would be a short option . In addition , USG Fiberock is lighter and promiscuous to cut than traditional fiber - reinforced concrete control panel .

Step 1

Measure the area where the USG Fiberock circuit board is to be install . If a cutting is necessary for the board to fit , mark the measurement on to the Fiberock board with a pencil .

Step 2

slew the board , if necessary , to the size need for your installation using a jig saw agree with a rough cut blade . It is best to practice the largest potential man of fiberboard to eliminate edges and other imperfections in the installation .

Step 3

Position the Fiberock into place where it is to be installed , checking that it fits snugly against any neighboring pieces , but does not overlap them . When positioning the Fiberock , make a note on the board where the wall studs are locate . If you are installing the Fiberock as a flooring substratum , it can be make love straightaway into the wood underlayment .

Step 4

Secure the Fiberock to the wall or trading floor using wood screws and an electric drill . Keep the jailer aligned with the wall studs to hold the Fiberock in spot firm . Drive the screws only as deep as necessary to make the screw head wealthy with the surface of the fiberock .

Install A Usg Suspended Ceiling

Examine the roof to discover the lowest pipe , duct or conduit . Measure three - quarters of an inch up toward the ceiling from the mark you made in Step 1 . Snap a chalk line at this location to indicate the height of your cap . Continue this chalk line all the way around the room . Place USG bulwark slant brackets along the chalk line . Screw the brackets into place every 2 column inch using a drill and drywall screws . tick the end of each main into the wall bracket , then support the independent every 4 feet using hanger conducting wire . If you are using 2 - by-2 tiles , install tees every 2 feet . apply a utility knife and straight border to cut tiles to fit as needed .

Things Needed

Warning

Fiberock board create gypsum dust when it is burn . wear down center and respiratory protection when working with this material .

References

…